I wanted to make a container with what was around me the last time I was out, so I chose a simple large design that would allow me to use willow for weaving. All I had was Crack Salix fragilis and Goat Willow Salix caprea. The places to look for suitable thin flexible stems are from a damaged, fallen, or pruned section of a larger tree as this species of tree as do several others, produces lots of new re-growth that can be utilised.
Crack willow is a dominant tree species near water. Its called crack willow due its brittle nature. The sections of the tree break off, land in the water then float downstream. As they make contact with the bank side, they easily propagate into the new surface and a new tree is born. Its a back up to the seed production and is why they are successful.
All stems gathered from a few separate trees
De-bark for some cordage.
Splitting down some larger diameter sections, for the main handle, base and ribs.
After heating over the fire to make them flexible, form two hoops from split sections and lash together with the bark which makes an excellent cordage. The cordage is very green so will shrink a little, but is adequate for a temporary fixing.
Then form the first of the weaving around the two hoops.
After forming a cross in the middle,wrap a thin weaver around one of the hooped sections, then go diagonally to the next one of the four, wrap around that and go diagonally to the next, and continue till you have gone round all four several times. Do again on the other end.
Into these end weaving s, make and fit four split and bent sections to form the base.
Then split down little finger thick stems around 1-2 Metres long, and weave in and out of the frame you have made. Some thinner sections can be used un-split - "In the round".
The knife pictured was the main tool used and all that is needed for the whole process, but a saw sped up the gathering time of the stems.
Ironically I found the crack willow easier and less breakable to work with than the goat willow. Both needed quite a bit of encouragement to work with, and it helped to work the stems by running them over the edge of a log to loosen the fibres within before weaving.
The end result seems very sturdy and I am very pleased with my new large foraging basket.
I am going to try hazel coppice growth in the round next time, and make a flatter bottom type, as well as try out other more flexible stems that need less processing.
Time to go practice wild food in the coming months with my new helper.